Wednesday, August 5, 2009

THE QUILT BOX: 2 & 3



Here are some "upgrades" on the Quilt Box.

THE BLUE BOX ironed out a couple of problems experienced in the original box which was the subject of the last posting. It also confirmed that this method of paper connection could result in a big highly decorative box of considerable stability.

I used a different method o
f module connection on this one. Although it removes the need for "patches" and "feet" to cover the holes at the intersections the disadvantage is that the corner pieces are somewhat bulky. This is particularly problematic around the top of the box. It does not have a lid because it would not sit well on top of this bulk.

Nevertheless, it is a good sturdy decorative open box.


As you can see in the last photograph of this model, I left the base fairly plain.








THE RED BOX uses the original method of module connection. The "legs" are identical but the "patches" now have their corners turned under. It seems to fit the rest of the pattern better.


The inserts are the same twisted cross design with the exception of the center panel in the front. The reason for this difference is that it permits the top lip to be tucked underneath the top section. This makes for a more secure connection than the method used on the original box.

The other lid flaps are simply tucked in, as before. If all the front and side panels were substituted with the insert used in the central front panel then all these five flaps could be tucked firmly underneath rather than just inserted loosely into the adjoining rim section. This would make it a very secure connection. The small air gap at the top front corners would disappear. The air gaps on the top back corners cannot easily be removed with a flush lid of this nature.




The inside of the box is much neater and less bulky than the blue box shown and discussed above.

NOTE: Having reviewed this posting I realize that the photo of the box parts awaiting 3D assembly is deceptive. It was taken early in the design process. After assembly I removed the cream connector pieces between the half squares which fold over the rim into the box and then redesigned how these sections hold together. Look at the last photo for further clarification.


Overall, I am reasonably happy with this version. It is time to make one from something other than cheap copy paper.




As I think I may have mentioned in previous posts, I use copy paper during the designing process because I destroy and throw out a lot of paper along the way to the final version. It would be wasteful to use expensive paper during this experimental stage.

During the design of this particular model there were a number of pieces of paper which became extremely battered from multiple creasings, re-creasinngs and total redesigning. This is usual.




It took some time to design the inserted module which I eventually used in the center front panel. Some versions worked but did not look "clean" or interesting. Others looked fine but did not work well, or even at all :-) As usual, I came up with some designs which did not fix the particular problem I was trying to solve but which are interesting in their own right and will probably be used in future models.

No comments: